The UP30 can be set up to 100 flight way-points,it basically meet the needs of most users because of the way-point distance without limitation.If the 100 way-points is not enough to be used,you can plan routes that divided into multiple flight segments of not more than 100 way-points,then use the function of modifying the flight way-point data during flight to upload the new 100 way-points during the period of the forthcoming flight end.

UP30 is not only a piece of circuit board,which integrates most of the components, even the communication station.The external only needs to be connected the remote-controlled receiver,GPS antenna,digital antenna and power source,so you only should install the flight control on the supplied installation accessories,then fix to the fuselage,install antenna,airspeed tube and other accessories.The whole installation process can be completed within 2 hours.The UP30 flight control has been built in PID parameters,and its adaptive models are very wide,it can control most of unmanned aerial vehicles without being changed. You can modify the PID parameters in real time,on account of using to display parametric curves during ground station in real time.Even though you start to adjust the parameters from the inner control,it only needs 30 minutes to complete to take off and landing.

The UP30 flight control is particularly developed the automatic aerial photography function for users.You can choose the shooting modes,such as fixed time,fixed distance and automatic exposure,way-point or manually control the starting and shooting of camera. It will synchronously record the location of aircraft,the attitude and other data for post processing.The simple camera connection:for the SLR camera with electronic shutter,it just needs to connect the shutter line with the control port of flight control camera;for the camera without electronic shutter,you can use the function of servo pressing the shutter.

The UP30 can control the camera or CCD platform in proportional remote control and automatic control mode.It can control the PTZ angle in automatic stabilization mode.

When it is subjected to any interference in the remote process,the receiver can not correctly receive the telecommand data,the flight control will automatically transfer to UAV airline flight mode.As long as manually shut down the receiver in the ground station at any time,the flight control will switch to UAV airline flight mode and does not receive any telecommand.

The UP30 is used GPS navigation autonomous flight,there is no limit between way-point distance,which means as long as the aircraft power is enough,it can fly to anywhere on Earth.It just is out of the communication distance,the waypoint data can not be modified.

The UP30 ground station can use the electronic map format (mapinfo),and also use the some custom marking area,line or point.You can also use scanned maps.For example,you can download a piece of Google map,saved as jpg. Format,then use the mapinfo for registration(the registration can be 3 to arbitrary numbers).There is a special scanned ground layer in the ground station software.It will be displayed on the based map after it joined in.

It currently supports fixed-wing:Inverted V-tail,Flying wing,Conventional layout etc.It supports airship at present:Cruciform tail,X-tail,Positive inverted Y-tail.

When the UP30 is connected with the receiver,it must be inserted into 1~6 channel simultaneously.The signal can be taken on the remaining remote control channel(servo power supply is connected solely),the receiver is powered by the flight control,and does not need another external power supply.